A multi-objective design optimisation of eco-friendly aircraft: the impact of noise fees on airplanes sustainable development

The current work deals with multi-objective optimisations including financial merit factors in the multi-disciplinary conceptual design of a commercial aircraft with a specific focus on noise social cost. The results of optimisations using financial and performance-oriented objective functions have been analysed and combined in a multi-objective optimisation problem using a three-dimensional objective vector. The main novelty of the present work is the analysis of social cost noise fees effectiveness integrated in financial models embracing a wider group of stakeholders’ interests. The foundations of this research lie on the air traffic increase envisaged in the next decades and the contextual growth of the urban areas nearby airport facilities. This scenario requires the aeronautical industry to handle the environment challenge taking into account all the social and economic effects. Indeed, the consolidated technology has approached a saturation point, therefore breakthrough concepts and configurations are mandatory. This matter is addressed as a highly multi-disciplinary problem within conceptual design framework. The financial model proposed is shown to highlight the need of appropriate noise fees as instruments to push all stakeholders towards a technology radical renewal and encourage the aeronautical industry towards a shared strategy in the development of an eco-friendly commercial aviation system.     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

渤海湾入海溶解无机氮总量控制研究

基于渤海湾近岸海域的实际调查结果,采取生态物理耦合模型,对渤海湾的主要污染物-溶解无机氮(DIN)的基准环境容量和极小剩余海洋环境容量进行了计算。结果表明,渤海湾DIN的极小剩余海洋环境容量在Ⅰ类和Ⅱ类水质标准下均为负值,渤海湾的DIN已经超标。结合实际的海水功能区水质管理目标,应重点控制非点源的排放,加强上游携带入境污染物的处理,从总量上控制DIN入海污染通量,改善渤海湾水质。     

灌河口表层土壤多环芳烃污染调查

为了解灌河口工业区表层土壤中多环芳烃的污染水平及健康风险。于2017年4月份在灌河口化工园区、火力发电厂和钢铁工业园区采集30个表层土壤样品,利用气相色谱-质谱联用仪(GC-MS)对16种优控ω(PAH)进行了检测。结果表明,30个采样点16种PAH的ω(T-PAHs)总为1 212.8~12 264.5 ng/g,平均值为3 504.8 ng/g。其中单体PAH以Fl为主,平均比例高达19.4%,其次为Pyr(16.7%)和B[a]P(9.6%)。单体PAH相关性分析表明了污染物来源的一致性,主要来源于本地工业区原油、生物质和煤的燃烧过程。根据加拿大土壤环境质量标准,灌河口工业区87%的土壤PAHs污染超过了安全值,存在潜在的生态风险。     

液液萃取-气相色谱法测定水质可萃取性石油烃C10~C40

建立了以环己烷为萃取剂、气相色谱法(氢火焰离子化检测器,FID)测定水质样品中可萃取性石油烃(C_(10)～C_(40))的分析方法。以正构烷烃混合标准溶液为定性和定量校准标准,以色谱峰面积总和与混合标准溶液总浓度建立校准曲线进行外标法定量。方法检出限为0.01 mg/L,经验证方法精密度和准确度良好。同时,分别以气相色谱法和红外光度法测定了地表水、污水处理厂出水、海水和化工废水等实际样品,对比实验结果表明,在可萃取性石油烃C_(10)～C_(40)的碳数范围内,气相色谱法的测试结果与红外光度法无明显差异,有较好的可比性。     

火灾发生率空间分异及影响因素研究

为了探究我国火灾空间聚集特征与影响因素的空间异质性，采用全局莫兰指数、局部莫兰指数、逐步回归模型、地理加权回归模型、地理探测器方法对我国地级市单元进行研究。研究结果表明:我国火灾发生率具有显著的聚集性；我国火灾发生率较低的“冷点”区域有1个，火灾发生率较高的“热点”区域有4个；人均GDP、城镇居民人均可支配收入、人口密度、年平均气温4 个因素的影响效应具有空间异质性。人均GDP与火灾发生率为正相关，另外3影响因素对火灾发生率的作用表现出正负2种相关关系；2因素交互作用要比单因素作用于火灾发生率时影响力更显著，各影响因素的交互作用类型有非线性增强型和双因子增强型2种。     

基于尾涡强度的无人机与民机纵向安全间隔评估研究

为了解决无人机频频入侵机场净空，与民航客机发生危险接近的问题，以碰撞风险为量化指标，对无人机与民机需要保持的纵向安全间隔进行评估研究。分析民机尾涡流场对无人机运行的影响，利用Crow近场涡强度消散理论，得到实际尾迹影响区改进Reich碰撞模板，据此建立CNS/GPS性能环境下的纵向间隔评估模型，通过Matlab进行间隔值求解。研究结果表明:模型可以较为准确地反映民机起飞初始爬升阶段无人机尾随运行时导航性能和尾涡迹对所需最小间隔值的影响，并得到给定安全目标水平的计算结果。     

基于ACF-AMDF的气井环空液面回波特征提取方法

为了精确有效地提取声波法检测气井环空液位的回波周期，在分析环空中测试波的传播特征及基音周期检测的基础上，提出1种基于检测信号短时自相关函数(ACF)及平均幅度差函数(AMDF)的液面回波周期提取方法；利用自主搭建的室内模拟实验系统开展了不同初始环空压力下环空液位检测实验；对检测信号进行中心削波处理并计算ACF/AMDF，提取出液面回波周期并与理论计算值对比分析；同时分析了现场环空液位检测信号，提取其回波周期。研究结果表明:提出的新方法能有效地用于提取环空液面回波周期；室内实验中，该方法最大误差绝对值为1.54%；该方法能够有效抑制液面回波信号中的随机噪声及接箍反射波等，处理后的信号曲线在回波周期处峰值更加突出、集中，而在其他位置更加平滑，提高了对液面回波周期特征的辨识能力。     

气相色谱-串联质谱法测定沉积物中多环芳烃

采用ASE法提取沉积物中16种多环芳烃,以固相萃取法净化提取液,用气相色谱-串联质谱法测定。通过优化测定条件,使方法在5.00μg/L~1 600μg/L范围内线性良好,方法检出限为0.15μg/kg~0.66μg/kg。空白石英砂的加标回收率为61.9%~121%,7次测定结果的RSD为2.6%~11.1%。